Installation Guide

6
STEP 2
1. Push the larger side of the tube over the smaller side. Repeat this for all tubes.
2. Put the eye bolts on the end of the ropes through the tubes. Use a wrench and a small
screwdriver to tighten the nuts on the eye bolts until the washers are tight against the tubes.
3. Close all four cover strips.
L
S
LS
S
L
SL
L
S
LS
S
L
SL
WRENCH
x4 x4
x4
NOTE: Use a small screwdriver to keep the
eye bolts from turning while tightening nuts.