Mountain View Wood Roof Kit 3431 ASSEMBLY INSTRUCTIONS Creative Cedar Designs • PO Box 4901 • Chattanooga, TN 37405 Visit our web site at: www.Creativecedardesigns.
ATTENTION: READ THIS BEFORE USE OF YOUR PLAYSET OR ACCESSORY: Observing the following statements and warnings reduces the likelihood of serious or fatal injury. This product has been designed for single family home/residential use only and is not intended for use in any public setting. Placement in public settings constitutes misuse of this product. Play Safe Installation Checklist: → No children are to be allowed to use the equipment until it is properly installed.
LIMITED WARRANTY Creative Cedar Design (CCD) offers many fun, interactive, and safe play sets. We only guarantee the original purchaser that this product is free of defects for 30 days from the date of purchase. The product registration card, along with a dated purchase receipt, must be returned to CCD within 30 days. Within a 30-day period, CCD will repair or replace, at our option, defective merchandise free of charge, provided that the defective part is a manufacturer’s defect and not seasonal check.
DIMENSIONS MINIMUM USE ZONE FOR PLAY EQUIPMENT SHALL EXTEND NO LESS THAN 72” FROM ALL SIDES OF THE PLAY STRUCTURE. SWING USE ZONE EXTENDS NO LESS THAN 158” SWINGS MUST HAVE A MINIMUM OF 8” ABOVE THE PROTECTIVE SURFACING.
TOOLS REQUIRED DRILL PHILLIPS BIT TAPE MEASURE TORX T-20 BIT SQUARE BIT CARPENTER SQUARE INCLUDED HARDWARE BOARD LIST 5 SAFETY GLASSES
STEP 1 Roof Panel Assembly x2 (7) WM772 SHINGLE WM766 ROOF SUPPORT Side View 1-1/8” Deck Screw (x14) 1. Assemble two Roof Panel(s) as shown. NOTE screw thru the shingle from the top into the support.
STEP 2 Dormer Assembly WMA01 LH DORMER PANEL Inside View WMA02 DORMER GABLE PANEL Side View WMA02 RH DORMER PANEL 1-1/8” Deck Screw (x4) 1. Assemble Dormer as shown.
STEP 3 1-1/2” Deck Screw(s) 1” Deck Screw ROOF PANEL ASSEMBLY 1” Deck Screw DORMER ASSEMBLY Side View 1” Deck Screw (x2) 1-1/2” Deck Screw (x2) 1. Attach Dormer Assembly to one Roof Panel Assembly as shown.
STEP 4 ROOF PANEL ASSEMBLY Flush 1-1/8” Deck Screw (x28) 1. Attach Roof Panel Assembly as shown.
STEP 5 WM772 SHINGLE 1-1/8” Deck Screw (x4) 1. Attach bottom Shingle as shown.
STEP 6 ROOF PANEL ASSEMBLY Flush 1-1/8” Deck Screw (x28) 1. Attach Roof Panel Assembly with Dormer as shown.
STEP 7 WM772 SHINGLE 1-1/8” Deck Screw (x4) 1. Attach bottom Shingle as shown.
CCD 3431 888-363-4967 Got Questions? We’ve got answers! Call our Customer Support Representatives Available Monday - Friday, 9am - 4pm (EST) Technical Support from experienced Customer Service Representatives who have actually built a swing set themselves. Visit our web site at: www.Creativecedardesigns.com © Creative Cedar Designs 2020 10.27.
