Instructions / Assembly

Phase 14:
SWING B EAM BRACE
& ARCH RAILS
(1) 1 3/8 X 5 5/16 X 65 SWING BEAM CROSS BRACE- LF250
(2) 1 X 5 5/16 X 44 3/4 SLIDE ARCH RAIL - LK224
(2) 1 X 5 5/16 X 44 3/4 LAD./ROCKW ARCH RAIL - LK225
(2) 1 X 5 5/16 X 30 1/2 BRIDGE ARCH RAIL - LK287
(2) 1 X 3 1/2 X 30 1/2 DOOR TOP RAIL - LM288
Phase Parts
STEP 1: INSERT (4) T-NUTS
INTO BACKSIDE OF
'LF250' FOR USE IN
LATER PHASE
(4)
5/16" T-nuts
(20)
Fender Washer
(4)
5/16" Split Washers
Phase Hardware
(4)
5/16"x4"HexBolts
2 1/2" Deck Screws
(16)
5/16" x 2 1/2" Lag Screws
(16)
LK224
LK225
LM288
LK287
LF250
(T-NUTS ON
BACKSIDE)
CENTER RAILS AND HOLD
FLUSH WITH RAILS BELOW
ATTACH WITH 2 1/2" LAG SCREW
& FENDER WASHER
LK225
FLUSH WITH TOP OF
UPRIGHT
LK224
2 1/2" DECK SCREWS
PUSH UP
AGAINST TOP
RAIL
31
2 1/2” DECK SCREWS
4” HEX BOLT
SPLIT WASHER
FENDER WASHER
BRIDGE BARRIER RAIL
NOT SHOWN FOR CLARITY
1/8” PRE-DRILL HOLES FOR
ALL LAG SCREWS