User's Manual

User Manual CForce N100

2 Installation

In different network modes, the line connection mode of CFORCE N100 is

different. Since the device is set to the bridge mode by default, this chapter

mainly describes the line connection mode of the bridge mode.

2.1 Connections and installation

The installation of CFORCE N100 is shown below:

Figure 2-1 Line connection

The CFORCE N100 device has two network ports (RJ45 ports) labeled

"PoE" and "LAN" ports. Because the device defaults to the bridge mode, the PoE

interface is connected to the PoE power port with the PoE type on the network

cable to provide 24V power and data connection to the CFORCE N100 device.

The LAN port of the device can be used to connect to the IP camera. Such as

video surveillance applications and other equipment. In general data