User's Manual
User Manual CForce N100
©2019 Creatcomm Technologies Co. Ltd. All rights reserved. All rights reserved. CreatComm, the CreatComm logo, are trademarks of
CreatComm. All other company and product names may be trademarks of their respective companies. While every effort is made to ensure
the information given is accurate, CreatComm does not accept liability for any errors or mistakes which may arise. Specifications and other
information in this document may be subject to change without notice. To learn more about CreatComm products, visit www.creatcomm.com.
12 Logout
Logout is used to log out of the product page. When the user clicks Logout in
the upper right corner of the page, the product page will jump to the login page.
FCC WARNING
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.