User's Manual

User Manual CForce N100

Figure 11 -1 AC Management

WTP Name: It’s the name of the device that is displayed on the AC.

WTP Location: It’s the location information that is displayed on the AC.

Add IP Type: Configure the IP address of the AC server. You can use the

manual addition method to specify the AC IP address to be connected, or you

can use the automatic acquisition method to automatically discover the IP

address of the AC server.

DTLS: Datagram Transport Layer Security, used for capwap message encryption.

AC IP: This IP address can add up to eight, add the IP address is AC

management interface’s IP and equipment is the same segment. After the AC

control function is enabled, click save, application, this time the device will take

effect on the AC configuration and restart, the device will join AC. After the AC

control function is enabled, the user is able to display the current state of the

page on the device page. After the AC control function is disabled, the user is

able to modify the device's page.

Note: The station must be able to join the AC after it is connected to an access

point that has been joined to the AC.