User's Manual

User Manual CForce N100

Figure 10-3 Antenna Calibration 5G

Note: When the bar graph shows the signal strength is higher than 60, said the

signal strength is poor, it is recommended that users adjust the equipment to

ensure that the two devices antenna angle is the best.

Iperf: Divided into servers and clients, used to test the throughput of the wireless

side between devices. Device 1 selects "Server", Device 2 selects "Client", and

Iperf Server fills in the IP address of Device 1. Iperf Thread is recommended to

set the number of threads running simultaneously when testing throughput. Iperf

Time is the number of seconds to run Iperf. Iperf Interval is the interval at which

throughput is displayed on the web page. Click the "Test" button when testing.

11 AC Management

The AC management page is shown below. After enabling this function, it

needs to be used with the AC management system.