User's Manual

User Manual CForce N100

Ping IP: User can input the destination IP address of another device, and click

Ping button. If that destination device is successfully connected to the CFORCE

N100 device, the result shows Alive, otherwise shows Not Alive.

Traceroute: Use the ICMP protocol to locate all routers between your computer

and the target computer.

Time to Reboot: This function allows you to periodically reboot the device.

NTP: If this NTP server is set, and the CFORCE N100 device can access to this

NTP server. CFORCE N100 device automatically calibrate the time and date

information with the NTP server and show the time information in the Status page.

Ping Watchdog: The ping watchdog sets the CFORCE N100 Device to

continuously ping a user-defined IP address (for example, it can be the IP

address of the AP the station is connecting to). If it is unable to ping under the

user defined constraints, the CFORCE N100 device will automatically reboot. It is

highly recommended that users enable this feature at the side of “Station” and

disable this feature at the side of “Access Point”.

Ping Interval: Specify time interval (in seconds) between the ping requests are

sent by the Ping Watchdog.

Ping IP Address: Specify an IP address of the target which will be monitored by

Ping Watchdog. If this feature is enabled at the side of “Station”, Ping IP Address

should be the IP address of the AP the Station is connecting to.

Startup Delay: Specify initial time delay (in seconds) until first ping request is

sent by the Ping Watchdog.

Ping Failure: Specify the number of ping replies. If the specified number of ping

replies is not received continuously, the Ping Watchdog will reboot the device.

Note: If users want to modify the parameters of Ping Watchdog, please disable it

first and then apply. When the web page shows that Ping Watchdog is really

disabled, users can now re-enable it with modified parameters.

Syslog: Enable the Syslog function and set the IP address of the PC where the

Syslog server is located. The server port is set to 514. After saving/applying, the

related log information can be seen on the system log interface of the status

display page and on the Syslog server.