User's Manual

User Manual CForce N100

parameters according to this distance to optimize the quality of the wireless

connection.

Distance: If the "ACK-Timeout Auto Adjustment" option is turned on, this

distance setting is disabled and the system will automatically test the distance of

the device and optimize the connection quality. If the user wants to set the

distance set by himself, you need to turn off the "ACK-Timeout Auto Adjustment"

option.

Aggregation: The same frames are combined and sent out. Enabling this

function has a certain increase in throughput, and the device is enabled by

default.

Multicast Data: With this feature, CFORCE N100 allows multicast packets to

pass through CFORCE N100.

ETH0 Interface Rate: Set the connection speed and duplex mode of the ETH0

port.

ETH1 Interface Rate: Set the connection speed and duplex mode of the ETH1

port.

Device Discover: When using this function, please use it with the dedicated tool

set. The tool set window will display the MAC address, IP address, product name,

and firmware name information of the discovered device. Note: When discovering

devices wirelessly, keep the multicast support enabled.

Client Isolation: Enable this feature to prevent devices connected to the same

access point, WDS access point, and WDS repeater from communicating with

each other. Even if the IP of each station is duplicated, it will not affect the

communication. This feature only exists in access point mode.

Max Station Limit: Set it to limit the number of stations and WDS stations

connected to the access point, WDS access point.

Signal LED: LED1, LED2 and LED3 are set to illuminate the signal intensity

value required by the device's 3 LED lights, and LED3 has the highest signal

strength value (LED3>LED2>LED1). The default settings are LED1: -86dB, LED2:

-71dB and LED3: -56dB. When the signal strength is higher than LED1 is lower

than LED2, LED1 is bright. When the signal strength is higher than LED2, lower