User's Manual

User Manual CForce N100

Figure 7-2 Firewall

1. Filter the device whose LAN port IP address is 192.168.1.100.

The firewall is enabled, the firewall default policy is Accept, the target of the IP

address filtering is Deny, the interface eth0, the IP protocol is IP, the source

IP/mask 192.168.1.100/32, and other values are null.

2. Filter the device whose MAC address is 00:00:00:00:00:01.

The firewall is enabled. The firewall default policy is Accept. The target of the

MAC filtering mode is Deny, the interface is eth0, the source MAC address is

00:00:00:00:00:01, and the other values are empty.

7.5 IP Aliases Settings

This function can add multiple IP addresses of the same network segment or

different network segments to a network interface. The IP aliases of different

interfaces cannot be the same.

7.6 Static Routes Settings

This feature allows you to set up a static route.

7.7 Traffic Shaping Settings

Traffic shaping is used to control the traffic of ingress/egress based on each

network port. As show below, the ingress of ath0 is limited to 10240Kbps, and the