User's Manual

User Manual CForce N100

WAN Netmask: The subnet mask of the WAN port, which exists only under static

IP and is used with the WAN IP.

Note: WAN IP address should not be the same as the IP devices of the internet

to avoid collision.

Primary DNS and Secondary DNS: DNS server, set to the value of the local

DNS server.

Gateway IP: Generally, the gateway address and the WAN IP address are on

the same network segment, and are generally set to the LAN port address of the

upper-level router.

LAN Network Settings: The LAN network settings are settings that exist in the

routing mode. You can add and manage LAN ports. The IP address of the LAN

port is generally the gateway address of the device in the lower LAN, and the

LAN port IP address and WAN IP address are not on the same network segment.

7.2 Bridge mode

In Bridge mode, there is no WAN port. The LAN port of the PoE adaptor, and

the LAN port of the CFORCE N100 device can all be the LAN port, and the user

can choose one of them to use as LAN port, and the IP address/Netmask

information setting is the same as Router mode.

7.3 Management Network Settings

The IP address of the device can be modified, and the management of the

device can be performed by setting the specified management interface.

7.4 Firewall Settings

When the user wants to shield some devices from CFORCE N100, a firewall

can be used to implement this function. The firewall is as shown in the following

figure: