User's Manual

User Manual CForce N100

7 Network

7.1 Router mode

In the router mode, CFORCE N100 is equivalent to a router, which has a

WAN port and a LAN port. At this time, the LAN port on the CFORCE N100 is

equivalent to the LAN port of the router, and the LAN port on the PoE power

supply is equivalent to the WAN port of the router. The route mode page is

shown below:

Figure 7-1 Router mode

WAN Mode: The WAN mode item is an option for the WAN port to obtain an IP

address. It is classified into static IP, DHCP (dynamic acquisition), and PPPoE.

When set to static IP, the user needs to manually set the IP, subnet mask, etc.

When set to DHCP, the device can automatically obtain an IP address from the

DHCP server; when set to PPPoE, the user needs to fill in the PPPoE server

name, Internet account number, and Internet access password. The device uses

the dial-up authentication method to obtain an IP address through the PPPoE

server.

WAN IP: Only exists under static IP. It can be set to the IP address of the same

network segment as the network to be connected.