User's Manual

User Manual CForce N100

Figure 6-3 Access Point Information

Frequency Scan List: When the device is in station mode, check “Enable”, click

“Select”, the user can enter “Frequency Scan List” to select the frequency by

himself, and check “Scope”. Users can set the frequency range by themselves.

When the frequency of the AP is not the frequency selected by the station, the

station cannot connect to the AP. Only when the frequency of the AP is one of

the station selections can be connected to each other (only the station page is

displayed).

Frequency MHz: This parameter needs to be set as the access point mode. The

default is "automatic selection". Check "Enable". Click "Select". Users can enter

the "Frequency Scan List" to select the frequency by themselves, and check the

"Range". You can set the frequency range yourself (only the access point page is

displayed).

Output Power: The output power of the wireless signal transmitted by the device.

The user adjusts according to the distance between the devices. When the

output power is increased, the transmitted signal distance and signal strength will

be improved.