User's Manual

User Manual CForce N100

4.2 Monitor

Figure 4-3 Monitor

Throughput: Refers to the amount of data passing through each section per unit

time. The throughput rate of the status display page is used to refer to the

amount of data transmitted over the network per unit time. It is the main indicator

for measuring network performance. Through it, users can monitor the speed of

data transmission by the device in real time.

Interfaces: Device interface MAC address, MTU, IP, RX Bytes, RX Errors, TX

Bytes, and TX Errors.

Routes Table: It is stored in a router that lists the routes to particular network

destinations, and in some cases, metrics (distances) associated with those

routes. The route table contains information about the topology of the network

immediately around it.

Bridge Table: It lists all the devices that communicate through the CFORCE

N100 device.

ARP Table: It lists the IP address and MAC address of the devices that

communicate through the LAN port of the CFORCE N100 device.

AP/Station Information: Showing the status information of the associated

devices. For example, if the CFORCE N100 device is an AP, and the associated

device is a Station, and this Station Information shows the related information of

the Station device. If the CFORCE N100 is a Station, and AP Information shows

the associated AP device’s information.

Syslog: Display the log information of CFORCE N100.