User's Manual

User Manual CForce N100

the steps in this section.

1. The first page shown after log in is the Status page, which indicates the

working status, current setting, software version and other information of the

CFORCE N100 device. Users can switch to other pages by clicking the left main

menus.

2. Click Wizard menu, the users can configure the device quickly, including

Network and Wireless settings and so on. It is Wizard-Network page as shown in

Figure 3-4, and this page helps to set the basic network parameters. The default

mode is Bridge mode, and the default LAN IP address is 192.168.1.36. If the user

wants to configure the device to Router mode, please click Network in the main

menu.

Note: If several CFORCE N100 devices are connected in the Point-to-Point or

Point-to-Multi-Point topologies, they must be configured to different IP address to

avoid collisions.

Figure 3-4 Wizard Network

3. Click "Next" to display the basic wireless parameter configuration and wireless

encryption options, as shown below. The two most common wireless modes for

CFORCE N100 devices are the “Station” and “Access Point."

Station mode: The device acts as a WIFI station, and it can be connected to a

normal home access point or CFORCE N100 access point.

Access Point mode: The CFORCE N100 device can be connected to a normal

wireless network card or to a CFORCE N100 device in “Station” mode. The

premise is that the wireless encryption options and SSID of both sides of the

wireless connection are configured consistently. For other detailed wireless

configurations, please click on the "Wireless Settings" menu on the left.

Note: If two CFORCE N100 devices need to be connected in point-to-point