Troubleshooting Guide

(110V/220V).
5.3.2 Check if the cable is normal.
5.3.3 Submit to the after-sales maintenance personnel for inspection.
6. Other Problems
6.1 Model is dislocation
6.1.1 Replace the model to eliminate the impact of the model itself
6.1.2 Check the speed of the slice setting, it is recommended to use a
print speed of 50mm/s.
6.1.3 Try to move the model location to see if it can solve such problems
6.1.4 Check the motor whether the fixing screw of the synchronous wheel
is loose.
6.1.5 Compare the belt at both side, Please confirm the belt is too loose or
too tight.
6.1.6 If it is winter, it is recommended to adjust the temperature of the
heat-bed to 60°C. If necessary, apply the solid glue when printing the first
layer to prevent the temperature from being too low, the cooling is too
fast.
6.1.7 If it is always misplaced on the same floor, consider the
motherboard problem, please contact the after-sales personnel to help
solve.
6.2 Profile problems (some Printers)
6.2.1 The thread of the profile is wrong, or there is no thread, the profile