Frequently Asked Questions

through the nozzle, then it’s likely you will need to clean out the
nozzle before proceeding. Many users have had success heating
their extruder to 100℃ and then manually pulling the filament out
(hopefully along with any debris that was inside!). Others prefer to
use the needle push the material backwards through the nozzle tip.
There are plenty of other methods and each extruder is different,
so please consult your printer manufacturer for precise instructions.
12:Stops Extruding in the Middle of a Print
If your printer was extruding properly at the beginning of
your print, but suddenly stopped extruding later on, there are
typically only a few things that could have caused this problem.
We will explain each common cause below and provide
suggestions for fixing the issue. If your printer was having trouble
extruding at the very beginning of the print, please see the Not
Extruding at Start of Print section.
(1) Out of filament
This one is pretty obvious, but before checking the other
issues, first verify that you still have filament leading into the
nozzle. If the spool has run out, you will need to load a new spool
before continuing the print.