User Manual

5
Chapter 4: Rigging and Safety
Recommended rigging position for the Creamsource Micro is with the cooling
fins in a vertical orientation. This allows for the best natural cooling of the unit.
It can be mounted in other positions BUT care must be taken not to smother the
cooling fins on the back of the unit. Keep a 10cm/4in. clearance around the unit
to maintain air flow.
If rigging the unit above people, from vehicles, moving platforms, or hanging from
any rigging, be sure to secure the unit through the safety-cable holes located
at each end of the unit using approved and correctly rated safety cables, chains
or carabiners.
Use appropriate safety cable for 4kg load. If the unit is to be
mounted suspended, it is necessary to replace the standard spigot
with a 28mm DIN or Euro spigot - please contact Outsight for
more details
CS_micro_UG_6PRINT.indd 5 23/01/2018 2:35 PM