User Manual

15
Chapter 7: Effects Modes
7.1 NORMAL LEVEL
Normal is for using the light as a normal solid light source. Intensity and Colour
Temperature (Bender models only) may be adjusted.
The ON/OFF button can be used to turn the light on or off, and the FLASH button
can be used to create flashes.
SETTING RANGE DESCRIPTION
BRIGHTNESS 0-100% Modeling light output level
COLOUR TEMP 2700k - 6500k Approximate colour temperature
7.2 DUAL LEVEL
Dual level allows two light levels to be set. This is useful if you need a modeling
light level, but then want to flash brighter for a lightning or strobe effect.
Use the ON/OFF button to turn on or off the modeling light, and FLASH button
to flash up to the Flash Level setting.
SETTING RANGE DESCRIPTION
BRIGHTNESS 0-100% Modeling light output level
FLASH LEVEL 1-50Hz Light output when FLASH button
pressed
COLOUR TEMP 2700k - 6500k Approximate colour temperature
7.3 STROBE AND FLASHES
The ON/OFF button can be used to turn the effect on or off, and the FLASH
button can be used to create ‘bursts’ of strobe
SETTING RANGE DESCRIPTION
BRIGHTNESS 0-100% Strobe brightness level
FREQUENCY 1-50Hz Frequency of strobe effect
DUTY CYCLE 1-99% Duty cycle of strobe effect - the ratio
between light OFF and ON times
COLOUR TEMP 2700-6500K Approximate colour temperature
CS_micro_UG_6PRINT.indd 15 23/01/2018 2:35 PM