User Manual

11
Note the Colour Temperature setting is only available on the Bender models, and the range will
be dependant on the particular model of Bender.
NORMAL
Normal is for using the light as a normal solid light source. Intensity and Colour Temperature
(Bender models only) may be adjusted. The ON/OFF button can be used to turn the light on or
o, and the FLASH button can be used to create ashes
SETTING RANGE DESCRIPTION
BRIGHTNESS 0-100% Light output level
COLOUR TEMP 2700-6500K Approximate colour temperature
DUAL LEVEL
Dual level allows two light levels to be set, one that is switched to when the FLASH button is
pressed. Useful if you need a modeling light level, but then want to ash brighter for a lighten-
ing or strobe eect. Use the ON/OFF button to turn on or o the modeling light, and FLASH
button to ash up to the Flash Level setting.
SETTING RANGE DESCRIPTION
BRIGHTNESS 0-100% Modeling light output level
FLASH LEVEL 0-100% Light output when FLASH button pressed
COLOUR TEMP 2700-6500K Approximate colour temperature
STROBE
Used for strobe eects. The ON/OFF button can be used to turn the eect on or o, and the
FLASH button can be used to create ‘bursts’ of strobe
SETTING RANGE DESCRIPTION
BRIGHTNESS 0-100% Strobe brightness level
FREQUENCY 1-50Hz Frequency of strobe eect
DUTY CYCLE 1-99% Duty cycle of strobe eect - the ratio between
light OFF and ON times
COLOUR TEMP 2700-6500K Approximate colour temperature