User Manual

1. The Creality Sonic Pad loads the camera device by default; if the camera is plugged in after

booting, after selecting and enabling the camera, the camera will display enabled, wait for 2

minutes before the screen appears (sometimes need to switch pages), or after inserting the

camera , the screen will appear after restarting the Creality Sonic Pad;

2. Some cameras are customized cameras, which are not output in YUV and Mjpeg formats.

Try to replace the camera and use it again;

3. Pull out the camera and use a U disk to check whether the USB is normal. If it is not normal,

please contact the after-sales service.

The camera can't be used normally after it is connected ?

Please refer to the printer adaptation guide link.

How to compile ﬁrmware and modify conﬁguration ﬁles for non-de-

fault printers ?

The model should be selected according to the actual situation when booting up or one-touch

change. The motherboard version needs to be disassembled to check, and the corresponding

relationship between the four choices of Ender-3 V2

a.[CR Touch logo in the upper left corner of the model diagram]Ender-3 V2 (V4.3.1 or

V4.2.2)----Corresponding to the model with CR Touch installed, the motherboard version is

V4.3.1 or V4.2.2

b.Ender-3 V2 (V4.3.1 or V4.2.2) ----Corresponding to the model without CR Touch installed, the

motherboard version is V4.3.1 or V4.2.2

c.Ender-3 V2 (V4.2.7) ----Corresponding to the model without CR Touch installed, the

motherboard version is V4.2.7

d.[CR Touch logo in the upper left corner of the model diagram]Ender-3 V2 (V4.2.7) ----Corre-

sponding to the model with CR Touch installed, the motherboard version is V4.2.7

What should I do if the Ender-3 V2 cannot be connected during the

booting operation or one-touch change?

Please save the ﬁle in a USB disk and insert it into the Creality Sonic Pad USB interface to read

the corresponding ﬁle.

The SD card is inserted into the printer, but the corresponding ﬁle

cannot be found in the Creality Sonic Pad?

Choose a common camera by yourself or refer to the recommended camera list provided by

Creality:

1 Logitech 920

2 Logitech C270i

3 HIKVISION DS-E12

4 Blue Enchantress T3300

5 PHILIPS SPL6506BM

6 X-LSWAB M600

How to choose a camera?