User Manual

Printed model with poor edge quality. What are the appropriate
acceleration and speed settings when slicing?
1.Check that the printer is properly connected to the Creality Sonic Pad.
2.Check whether the power connection of the Creality Sonic Pad and the printer is normal.
Abort printing during printing
1. Enter configuration-camera to see if there is a real-time image, if there is no real-time image,
it should be turned on first;
2. Confirm that the camera is a general-purpose USB camera, and the real-time screen has
been turned on;
3. Enter Configure - Local Information to check whether the available storage is insufficient;
4. Check whether the time-lapse video has been turned on and whether the frequency of the
time-lapse video is set correctly. (the frequency should be less than the number of slice layers)
Time-lapse photography did not shoot successfully
The vibration sensor should be installed on the hotend . You can print the bracket which the
model file provided by Creality, and then use the screws to fasten the sensor to the bracket
without direction requirement.
Where should the vibration sensor be placed when resonance
compensation is automatically detected? Are there any orientation
requirements ?
1. Check whether the network is normal, and the upgrade package can be downloaded only if
the network is normal;
2. If it prompts "download failed" when the network is normal, please check whether the
storage of Creality Sonic Pad is more than 500MB. If the storage is insufficient, please try to
clean up some of the slice files or time-lapse video files to ensure that the available space is
more than 500MB before trying to upgrade.
3. If it still prompted with "upgrade failed" when the network is normal and the available
storage is sufficient, please contact the after-sales service.
Failed to upgrade online
You can refer to the slicing software configuration parameter suggestions provided by Creality.
The default supported printers (Ender-3 V2 / Ender-3 S1 / Ender-3 S1 Pro) can directly import
the corresponding parameter configuration files in the slicing software.
add in config file
[filament_switch_sensor filament_sensor]
How to configure the file to be compatible with filament run-out
detection function ?
30