Installation Manual

Step 5. Z axis motor assembly installation
Step 1. Rotate base (Ba) 180°until the back is facing
towards you.
Step 2. Position the hole of Z-axis motor assembly at
the threaded hole of the aluminum profile (L) in the
base (Ba), secure with M4*18 screws, and tighten the
screws with a 2.5mm Hexagon wrench.
Step 3. Use a 2.5mm Hexagon wrench to loosen the
screws of the Z-axis coupling to prepare for insertion
of the lead screw.
Step 4. Insert the T8 lead screw into the coupling, and
tighten the screw that was loosened in the previous
step.
Loosen
the screw
Prepare the following parts:
a. T8 Acme lead screw (1x)
b. M4x18 hex drive flat head
screws (2x)
c. Z-axis motor assembly (Zm)
(1x)
d. 2.5mm Allen key