User Manual

- 9 -
best balance between speed and accuracy.
4、High Quality（0.1mm）：This mode sacrifices print speed to provide better
print accuracy. If you want to improve the printing efficiency, you can also try to use
the relevant settings of the CR-100.
Others：
Holder Bottom Brim Bottom Raft
1、Printing the holder: It is default to print the holder for the lower surface of
the model is inclined more than 45°, So that the model is not easy to collapse and
has a better shape structure. you can adjust the angle of the model in the full
configuration mode.
2、Bottom Brim：A few round will be printed on the outside of the bottom of
the model to privide better adhesion for the model
3、Bottom Raft：A raft will be printed on the underside of the model, to provide
a flat print surface for the model even when the platform is slightly tilted