Datasheet

Manufactured by :
CRC Industries Europe NV
Touwslagerstraat 1 – 9240 Zele – Belgium
Tel (32) (0) 52/45.60.11 Fax (32) (0) 52/45.00.34
www.crcind.com
TECHNICAL DATA SHEET
2/2
CRC MULTILUBE
Ref. : 10703
4. DIRECTIONS
• Do not mix with other lubricants. Clean parts to be lubricated with CRC Quickleen and let dry.
• Apply evenly onto the friction point and allow product to penetrate and set for a few minutes.
• Move the friction points during the penetration phase
• Excess or spilled product can be removed with CRC Quickleen.
• Do not use on equipment under electrical tension.
• A safety data sheet (MSDS) according EU directive 93/112 is available for all CRC products.
5. TYPICAL PRODUCT DATA (without propellant)
Appearance : transparent, fresh blue
Specific gravity @ 20°C : 0,80
Flash point (solvent, closed cup) : < 0 °C
Dry film properties
Specific gravity @ 20°C : 0.87
Kinematic viscosity @ 40°C : 1795 - 1995 mm
2
/s.
Flash point (open cup) : 230°C
Brugger wear test : 65N/mm
2
Four ball wear ASTM D2266 solids mm² : 0,25
Operating temperature : -35°C till 200°
6. PACKAGING
Aerosol: 12 x 500 ml
All statements in this publication are based on service experience and/or laboratory testing. Because of the wide variety
of equipment and conditions and the unpredictable human factors involved, we recommend that our products be tested
on-the-job prior to use. All information is given in good faith but without warranty neither expressed nor implied.
This Technical Data Sheet may already have been revised at this moment for reason such as legislation, availability of
components and newly acquired experiences. The latest and only valid version of this Technical Data Sheet will be sent
to you upon simple request or can be found on our website: www.crcind.com.
We recommend you to register on this website for this product so you will be able to receive any future updated version
automatically.
Version : 10703 03 0602 04
Date : 09 February 2004