Cut Sheet
This product is miscible in water.
Large Spills: Stop the flow of material, if this is without risk. Dike the spilled material, where this is
possible. Cover with plastic sheet to prevent spreading. Absorb in vermiculite, dry sand or earth
and place into containers. Prevent product from entering drains. Following product recovery, flush
area with water.
Small Spills: Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination.
Never return spills to original containers for re-use. For waste disposal, see section 13 of the SDS.
Methods and materials for
containment and cleaning up
Avoid release to the environment. Prevent further leakage or spillage if safe to do so. Avoid
discharge into drains, water courses or onto the ground. Inform appropriate managerial or
supervisory personnel of all environmental releases.
Environmental precautions
7. Handling and storage
Provide adequate ventilation. Do not get this material in contact with eyes. Avoid contact with eyes,
skin, and clothing. Wear appropriate personal protective equipment. Avoid release to the
environment. Observe good industrial hygiene practices. Use care in handling/storage. For product
usage instructions, please see the product label.
Precautions for safe handling
Store in original tightly closed container. Store away from incompatible materials (see Section 10
of the SDS).
Conditions for safe storage,
including any incompatibilities
8. Exposure controls/personal protection
Occupational exposure limits
US. AIHA Workplace Environmental Exposure Level (WEEL) Guides
ValueComponents
Form
Type
TWA 10 mg/m3 Aerosol.Propylene glycol (CAS
57-55-6)
No biological exposure limits noted for the ingredient(s).
Biological limit values
Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates
should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation,
or other engineering controls to maintain airborne levels below recommended exposure limits. If
exposure limits have not been established, maintain airborne levels to an acceptable level. Eye
wash facilities and emergency shower must be available when handling this product.
Appropriate engineering
controls
Individual protection measures, such as personal protective equipment
Wear safety glasses with side shields (or goggles) and a face shield.
Eye/face protection
Skin protection
Wear protective gloves such as: Nitrile. Rubber.
Hand protection
Wear appropriate chemical resistant clothing.
Other
If engineering controls are not feasible or if exposure exceeds the applicable exposure limits, use a
NIOSH-approved cartridge respirator with an organic vapor cartridge. Use a self-contained
breathing apparatus in confined spaces and for emergencies. Air monitoring is needed to
determine actual employee exposure levels.
Respiratory protection
Wear appropriate thermal protective clothing, when necessary.
Thermal hazards
Always observe good personal hygiene measures, such as washing after handling the material
and before eating, drinking, and/or smoking. Routinely wash work clothing and protective
equipment to remove contaminants.
General hygiene
considerations
9. Physical and chemical properties
Appearance
Liquid.
Physical state
Liquid.
Form
Blue green.
Color
Surfactant.
Odor
Odor threshold
Not available.
pH
10.5 - 12.2
Melting point/freezing point
-121 °F (-85 °C) estimated
3 / 8
Material name: Inflatable Boat Cleaner
MK3832 Version #: 02 Revision date: 09-10-2015 Issue date: 08-20-2015
SDS US