MSDS

7. Handling and storage
Pressurized container: Do not pierce or burn, even after use. Do not use if spray button is missing
or defective. Do not spray on a naked flame or any other incandescent material. Do not smoke
while using or until sprayed surface is thoroughly dry. Do not cut, weld, solder, drill, grind, or
expose containers to heat, flame, sparks, or other sources of ignition. Use caution around
energized equipment. The metal container will conduct electricity if it contacts a live source. This
may result in injury to the user from electrical shock and/or flash fire. Do not get this material in
contact with eyes. Use only in well-ventilated areas. Wear appropriate personal protective
equipment. Avoid release to the environment. Observe good industrial hygiene practices. For
product usage instructions, please see the product label.
Precautions for safe handling
Level 1 Aerosol.
Contents under pressure. Do not expose to heat or store at temperatures above 120°F/49°C as
can may burst. Do not puncture, incinerate or crush. Do not handle or store near an open flame,
heat or other sources of ignition. Store in a well-ventilated place. Store away from incompatible
materials (see Section 10 of the SDS).
Conditions for safe storage,
including any incompatibilities
8. Exposure controls/personal protection
Occupational exposure limits
US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR 1910.1000)
ValueComponents Type
PEL 600 mg/m3Dipropylene glycol
monomethyl ether (CAS
34590-94-8)
100 ppm
US. ACGIH Threshold Limit Values
ValueComponents Type
STEL 150 ppmDipropylene glycol
monomethyl ether (CAS
34590-94-8)
TWA 100 ppm
US. NIOSH: Pocket Guide to Chemical Hazards
ValueComponents Type
STEL 900 mg/m3Dipropylene glycol
monomethyl ether (CAS
34590-94-8)
150 ppm
TWA 600 mg/m3
100 ppm
No biological exposure limits noted for the ingredient(s).
Biological limit values
Exposure guidelines
US - California OELs: Skin designation
Dipropylene glycol monomethyl ether (CAS 34590-94-8) Can be absorbed through the skin.
US - Tennessee OELs: Skin designation
Dipropylene glycol monomethyl ether (CAS 34590-94-8) Can be absorbed through the skin.
US ACGIH Threshold Limit Values: Skin designation
Dipropylene glycol monomethyl ether (CAS 34590-94-8) Can be absorbed through the skin.
US NIOSH Pocket Guide to Chemical Hazards: Skin designation
Dipropylene glycol monomethyl ether (CAS 34590-94-8) Can be absorbed through the skin.
US. OSHA Table Z-1 Limits for Air Contaminants (29 CFR 1910.1000)
Dipropylene glycol monomethyl ether (CAS 34590-94-8) Can be absorbed through the skin.
Good general ventilation (typically 10 air changes per hour) should be used. Ventilation rates
should be matched to conditions. If applicable, use process enclosures, local exhaust ventilation,
or other engineering controls to maintain airborne levels below recommended exposure limits. If
exposure limits have not been established, maintain airborne levels to an acceptable level. Provide
eyewash station.
Appropriate engineering
controls
Individual protection measures, such as personal protective equipment
Wear safety glasses with side shields (or goggles) and a face shield.
Eye/face protection
3 / 9
Material name: Ultra Vinyl Cleaner
MK2718 Version #: 01 Issue date: 08-20-2015
SDS US