Datasheet

ManualsBrandsCRC ManualsChemicalsElectric Motor and Equipment Cleaner Spray 500 ml

TECHNICAL DATA SHEET

2/2

CRC LECTRA CLEAN II

Ref. : 10107

5. TYPICAL PRODUCT DATA (without propellant)

Appearance : clear liquid

Odour : mild/typical

Distillation range : 180-220°C

Freezing point : < -30°C

Flash point (closed cup) : 63°C

Specific gravity (@ 20°C) : 0,825

Kauri-Butanol value : 84

Vapour density (vs. air = 1) : > 5

Evaporation rate (vs. ether = 1) : 150

Drying time (vertical)(see added note) : 3 hrs.

Plastics compatibility (Bellcore)

on Lexan : fails

on Noryl : fails

on ABS : fails

6. PACKAGING

aerosol : 12 x 500 ml

bulk : 4 x 5 l

20 l

200 l

Note : Drying Time

Parts cleaned with CRC Lectra Clean II will not dry as rapidly as those cleaned with chlorinated or low flash point

solvents. Drying time will depend considerably on surface geometry and environmental conditions (temperature,

% humidity, ventilation, ...). Reducing the liquid film thickness or the parts will also shorten drying time; this can be

done by allowing excess cleaner to drip off and/or by using a gentle air knife blow off. Drying time can also be

shortened with warm air blowers. Blowers should use fresh air (not recirculated air) to keep solvent

concentrations low. Parts typically dry in less than half an hour if warm air is used at low flow rates. Higher flow

rates dry even quicker. Maximum allowed temperature is 50°C.

All statements in this publication are based on service experience and/or laboratory testing. Because of the wide

variety of equipment and conditions and the unpredictable human factors involved, we recommend that our

products be tested on-the-job prior to use. All information is given in good faith but without warranty neither

expressed nor implied.

This Technical Data Sheet may already have been revised at this moment for reason such as legislation,

availability of components and newly acquired experiences. The latest and only valid version of this Technical

Data Sheet will be sent to you upon simple request or can be found on our website:

www.crcind.com.

We recommend you to register on this website for this product so you will be able to receive any future updated

version automatically.

Version : 10107 03 0899 03

Date : 25 september 2003

Manufactured by :

CRC Industries Europe NV

Touwslagerstraat 1 – 9240 Zele – Belgium

Tel (32) (0) 52/45.60.11 Fax (32) (0) 52/45.00.34