Datasheet

ManualsBrandsCRC ManualsChemicalsElectric Motor and Equipment Cleaner Spray 500 ml

TECHNICAL DATA SHEET

1/2

CRC LECTRA CLEAN II

Ref. : 10107

1. GENERAL DESCRIPTION

Electric motor and equipment cleaner/degreaser.

CRC Lectra Clean II is a hydrocarbon-based cleaner/degreaser which replaces chlorinated

solvents in electrical cleaning and degreasing applications. Effective removal of grease, oil,

dirt and other contaminants from electric motors, parts and equipment.

2. FEATURES

• Controlled evaporation for enhanced cleaning action.

• High flash point for application safety.

• Improves operating efficiency.

• Promotes longer equipment life.

• Reduces maintenance time by in-place cleaning without dismantling.

• Non-conductive and non-corrosive.

• Low odour.

• Leaves no residue

• Aerosols are equipped with the 360° (upside-down) spray valve for added convenience.

• High purity CO

propellant, giving an active product content of 97%.

3. APPLICATIONS

Effective removal of grease, oil, dirt and other contaminants from :

• Electric Motors

• Pumps

• Generators

• Lifts

• Insulators

• Hoists

• Compressors

• Switches

• Corroded machinery and parts

• Material handling equipment.

4. DIRECTIONS

• Apply liberally by spraying or dipping and allow excess to run off. Use extension tube for

hard-to-reach areas. In dipping bath applications, agitation or slight heating (up to 40°C)

enhances cleaning action. May also be applied by wiping with a clean rag or by

brushing.To clean equipment interior; covers, plates, etc. should be removed prior to

product application.

• Allow to air dry or dry with absorbent cloth (see also added note). After cleaning, use CRC

2-26 for lubrication and protection.

• May be harmful to some plastics, adhesives or coatings.Test on a small area before using.

Do not use on sensitive electronic equipment such as tape decks,VCR’s, computers, etc.

Use one of CRC’s contact cleaner products for this.

• Do not use on energised equipment.Allow to dry thoroughly and vent before reactivating

system.

• A safety data sheet (MSDS) according EU93/112 is available for all CRC products.

Manufactured by :

CRC Industries Europe NV

Touwslagerstraat 1 – 9240 Zele – Belgium

Tel (32) (0) 52/45.60.11 Fax (32) (0) 52/45.00.34

www.crcind.com

Summary of content (2 pages)

PAGE 1
TECHNICAL DATA SHEET 1/2 CRC LECTRA CLEAN II Ref. : 10107 1. GENERAL DESCRIPTION Electric motor and equipment cleaner/degreaser. CRC Lectra Clean II is a hydrocarbon-based cleaner/degreaser which replaces chlorinated solvents in electrical cleaning and degreasing applications. Effective removal of grease, oil, dirt and other contaminants from electric motors, parts and equipment. 2. FEATURES • Controlled evaporation for enhanced cleaning action. • High flash point for application safety.
PAGE 2
TECHNICAL DATA SHEET 2/2 CRC LECTRA CLEAN II Ref. : 10107 5. TYPICAL PRODUCT DATA (without propellant) Appearance Odour Distillation range Freezing point Flash point (closed cup) Specific gravity (@ 20°C) Kauri-Butanol value Vapour density (vs. air = 1) Evaporation rate (vs. ether = 1) Drying time (vertical)(see added note) Plastics compatibility (Bellcore) on Lexan on Noryl on ABS : : : : : : : : : : clear liquid mild/typical 180-220°C < -30°C 63°C 0,825 84 >5 150 3 hrs. : : : fails fails fails 6.