Datasheet

Manufactured by :
CRC Industries Europe BVBA
Touwslagerstraat 1 – 9240 Zele – Belgium
Tel (32) (0) 52/45.60.11 Fax (32) (0) 52/45.00.34
www.crcind.com
TECHNICAL DATA
2/2
CRC CRICK 130
Developer for non-destructive testing
Ref. : 10879
• Penetrant application
Shake the can of Crick 120 prior to use. Spray the penetrant in a light, even film on the
surface, wetting all areas to be controlled. Allow to drain for 10 to 20 minutes.
• Excess penetrant removal
Remove excess of penetrant by wiping the surface using a lint-free cloth. Apply water (Crick
120 is water washable) until all visible, coloured traces are removed. Care must be taken that
only disturbing penetrant on the surface is removed. Dry properly.
• Development
Shake the can of Crick 130 thoroughly prior to use. Spray a light, homogeneous coat of
developer from a distance of about 20 cm. Avoid any excess developer to avoid masking the
finest flaws. Allow to develop for at least 7 minutes so that imperfections are visible.
• Visual inspection of defects
As time passes, the defects will appear as red spots or lines on a white background. The
speed of appearance, the shape and dimensions can give information about the nature of the
defects. If necessary, post-clean the controlled surface and protect against corrosion with
one of CRC’s corrosion protection products.
A safety data sheet (MSDS) according EU-directive 93/112 is available for all CRC products.
5. TYPICAL PRODUCT DATA (without propellant)
Appearance : powder dispersed in a solvent blend
Color : white
Odor : solvent
Application temperature : > 10°C
Specific gravity (@ 20°C) : 0,781
Boiling range (solvent) : 40 - 65°C
Flash point liquid : < 0°C
Auto-ignition temperature : > 200°C
Solubility in water : not soluble
6. PACKAGING
aerosol : 12 x 500 ml
All statements in this publication are based on service experience and/or laboratory testing. Because of the wide
variety of equipment and conditions and the unpredictable human factors involved, we recommend that our
products be tested on-the-job prior to use. All information is given in good faith but without warranty neither
expressed nor implied.
This Technical Data Sheet may already have been revised at this moment for reason such as legislation,
availability of components and newly acquired experiences. The latest and only valid version of this Technical
Data Sheet will be sent to you upon simple request or can be found on our website: www.crcind.com
.
We recommend you to register on this website for this product so you will be able to receive any future updated
version automatically.
Version : 10879 03 0702 06
Date : 24 December 2008