Datasheet

TECHNICAL DATA
2/3
CRC 3-36
Ref. : 10010
• MATERIAL STORAGE
- Tubings
- Castings
- Gears
- Weld rod and wire
• MAINTENANCE
- Air actuated tools
- Conveyors
- Frozen joints
- Locks
- Hoists
4. DIRECTIONS
• Spray in light, even films to lubricate and protect metal surfaces. For electrostatic spraying,
addition of polar solvents (butanol, nitropropane, ...) may be necessary.
• Apply liberally and allow to penetrate to free rusted parts. Full penetration may require
several hours.
• To displace moisture, spray wet surfaces until run-off is clear and moisture-free.
• To be removed by solvent cleaners (CRC Industrial Degreaser, CRC Fast Dry
Degreaser,...) or alkaline degreasing before surface treatment.
• For application of CRC 3-36 in dipping baths, customers should take care to stir from time
to time (to distribute small amounts of deposits) and to prevent excessive evaporation of
solvent. When stable emulsions have been formed, the bath should be emptied and
cleaned, and the product replaced.
• Do not use on energized equipment. Use in a well ventilated area.
• A safety data sheet (MSDS) according EU-Directive 93/112 is available for all CRC
products.
5. TYPICAL PRODUCT DATA (without propellant)
Appearance : blue-green, clear
Specific gravity (@ 20°C) : 0.83
Distillation range of solvents : 190-250°C
Freezing point : -50°C
Flash point (open cup) : 78°C
Dynamic viscosity (@ 20°C) : 3.9 mPa.s
Ultimate film thickness : 2.10
-6
m.
(@ 20°C, after a 24 hr spread)
Maximum expected coverage : 100 m
2
/l.
(@ 20°C, after a 24 hr spread)
Solvent dissipation (@ 20°C, thin film) : 2-4 h.
Film properties (after evaporation of solvent)
Dynamic viscosity (@ 20°C) : 64 mPa.s
Falex true load failure : 8900 N
(ASTM D 3233, Proc.A)
Salt spray resistance (*) : 65 h.
Manufactured by :
CRC Industries Europe NV
Touwslagerstraat 1 – 9240 Zele – Belgium
Tel (32) (0) 52/45.60.11 Fax (32) (0) 52/45.00.34
www.crcind.com