MSDS

Product Name: Zinc-It® Instant Cold Galvanize Product Number (s): 18412
Page 2 of 6
Section 3: Composition/Information on Ingredients
COMPONENT CAS NUMBER % by Wt.
Zinc Elemental 7440-66-6 30 – 60
Toluene 108-88-3 10 – 30
Naphtha 8030-30-6 1 - 5
Isobutane 75-28-5 7 - 13
Propane 74-98-6 5 - 10
Section 4: First Aid Measures
Eye Contact:
Immediately flush with plenty of water for 15 minutes. Call a physician if irritation persists.
Skin Contact:
Remove contaminated clothing and wash affected area with soap and water. Call a physician
if irritation persists. Wash contaminated clothing prior to re-use.
Inhalation:
Remove person to fresh air. Keep person calm. If not breathing, give artificial respiration. If
breathing is difficult give oxygen. Call a physician.
Ingestion:
Do not induce vomiting. Get medical attention.
Note to Physicians:
Aspiration hazard. Treat symptomatically.
Section 5: Fire-Fighting Measures
Flammable Properties:
This product is extremely flammable in accordance with aerosol flammability
definitions (16 CFR 1500.3(c)(6) ).
Flash Point: 39 F (TCC) Upper Explosive Limit: 9.5
Autoignition Temperature: > 800 F Lower Explosive Limit: 1.0
Suitable Extinguishing Media:
Water, carbon dioxide, dry chemical, foam.
Products of Combustion:
Hydrocarbon fumes and smoke. Carbon monoxide where combustion is incomplete.
Protection of Fire-Fighters:
Firefighters should wear self-contained, NIOSH-approved breathing apparatus for
protection against suffocation and possible toxic decomposition products. Proper eye
and skin protection should be provided. Use water spray to keep fire-exposed
containers cool and to knock down vapors which may result from product
decomposition.
Section 6: Accidental Release Measures
Personal Precautions:
Use personal protection recommended in Section 8.
Environmental Precautions:
Take precautions to prevent contamination of ground and surface waters. Do not flush
into sewers or storm drains.