MSDS

Hazard(s) not otherwise
classified (HNOC)
None known.
3. Composition/information on ingredients
Mixtures
CAS number %Chemical name Common name and synonyms
115-10-6Dimethyl ether
30 - 40
7732-18-5Water
20 - 30
5131-66-8Propylene Glycol Monobutyl Ether
1 - 3
Specific chemical identity and/or percentage of composition has been withheld as a trade secret.
4. First-aid measures
Inhalation
Move to fresh air. Call a physician if symptoms develop or persist.
Skin contact
Rinse skin with water/shower. Take off contaminated clothing and wash before reuse. Get medical
attention if irritation develops and persists.
Eye contact
Immediately flush eyes with plenty of water for at least 15 minutes. Remove contact lenses, if
present and easy to do. Continue rinsing. Get medical attention if irritation develops and persists.
Ingestion
Rinse mouth. Drink plenty of water. Do not induce vomiting. In the unlikely event of swallowing
contact a physician or poison control center.
Most important
symptoms/effects, acute and
delayed
Severe eye irritation. Symptoms may include stinging, tearing, redness, swelling, and blurred
vision.
Indication of immediate
medical attention and special
treatment needed
Provide general supportive measures and treat symptomatically. Keep victim under observation.
Symptoms may be delayed.
General information
IF exposed or concerned: Get medical advice/attention. Ensure that medical personnel are aware
of the material(s) involved, and take precautions to protect themselves. Show this safety data
sheet to the doctor in attendance.
5. Fire-fighting measures
Suitable extinguishing media
Water spray. Dry chemical powder. Carbon dioxide (CO2).
Unsuitable extinguishing
media
None known.
Specific hazards arising from
the chemical
Flammable or explosive mixtures with air maybe formed. Contents under pressure. Pressurized
container may rupture when exposed to heat or flame. During fire, gases hazardous to health may
be formed.
Special protective equipment
and precautions for firefighters
Firefighters must use standard protective equipment including flame retardant coat, helmet with
face shield, gloves, rubber boots, and in enclosed spaces, SCBA.
Fire-fighting
equipment/instructions
In case of fire: Stop leak if safe to do so. Move containers from fire area if you can do so without
risk. Containers should be cooled with water to prevent vapor pressure build up.
General fire hazards
Extremely flammable aerosol. Contents under pressure. Pressurized container may rupture when
exposed to heat or flame.
6. Accidental release measures
Personal precautions,
protective equipment and
emergency procedures
Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Keep out of
low areas. Many gases are heavier than air and will spread along ground and collect in low or
confined areas (sewers, basements, tanks). Wear appropriate protective equipment and clothing
during clean-up. Emergency personnel need self-contained breathing equipment. Do not touch
damaged containers or spilled material unless wearing appropriate protective clothing. Ventilate
closed spaces before entering them. Local authorities should be advised if significant spillages
cannot be contained. For personal protection, see section 8 of the SDS.
Methods and materials for
containment and cleaning up
Eliminate all ignition sources (no smoking, flares, sparks, or flames in immediate area). Keep
combustibles (wood, paper, oil, etc.) away from spilled material. Stop the flow of material, if this is
without risk. Wipe up with absorbent material (e.g. cloth, fleece). Clean surface thoroughly to
remove residual contamination. For waste disposal, see section 13 of the SDS. Prevent entry into
waterways, sewer, basements or confined areas.
Environmental precautions
Avoid discharge into drains, water courses or onto the ground.
2 / 8
Material name: Reflective Mining Paint - Yellow
18021 Version #: 01 Issue date: 12-17-2014
SDS US