MSDS

Supplemental information
When exposed to water or humid air, product evolves Methyl ethyl ketoxime.
3. Composition/information on ingredients
Mixtures
CAS number %Common name and synonymsChemical name
70131-67-8Polydimethylsiloxane,
hydroxy-terminated
>= 60
63148-62-9Polydimethylsiloxane
10 - 20
68611-44-9Fumed silica
5 - 10
1309-37-1Iron oxide
5 - 10
22984-54-9Methyl tri(ethylmethylketoxime)
silane
3 - 5
2224-33-1Ethyl tri(ethylmethylketoxime) silane
1 - 3
7727-37-9Nitrogen
1 - 3
Specific chemical identity and/or percentage of composition has been withheld as a trade secret.
4. First-aid measures
Move to fresh air. Call a physician if symptoms develop or persist.
Inhalation
Remove contaminated clothing immediately and wash skin with soap and water. In case of
eczema or other skin disorders: Seek medical attention and take along these instructions.
Skin contact
Rinse with water. Get medical attention if irritation develops and persists.
Eye contact
In the unlikely event of swallowing contact a physician or poison control center. Rinse mouth.
Ingestion
Dermatitis. Rash. May cause an allergic skin reaction.
Most important
symptoms/effects, acute and
delayed
Provide general supportive measures and treat symptomatically. Keep victim under observation.
Symptoms may be delayed.
Indication of immediate
medical attention and special
treatment needed
Ensure that medical personnel are aware of the material(s) involved, and take precautions to
protect themselves. Wash contaminated clothing before reuse.
General information
5. Fire-fighting measures
Foam. Dry chemicals. Carbon dioxide (CO2). Water spray.
Suitable extinguishing media
None known.
Unsuitable extinguishing
media
Contents under pressure. When exposed to water or humid air, product evolves Methyl ethyl
ketoxime.
Specific hazards arising from
the chemical
Firefighters must use standard protective equipment including flame retardant coat, helmet with
face shield, gloves, rubber boots, and in enclosed spaces, SCBA.
Special protective equipment
and precautions for firefighters
Fire-fighting
equipment/instructions
In case of fire: Stop leak if safe to do so. Move containers from fire area if you can do so without
risk.
6. Accidental release measures
Keep unnecessary personnel away. Keep people away from and upwind of spill/leak. Keep out of
low areas. Wear appropriate protective equipment and clothing during clean-up. Avoid breathing
gas. Do not touch damaged containers or spilled material unless wearing appropriate protective
clothing. Ensure adequate ventilation. Local authorities should be advised if significant spillages
cannot be contained. For personal protection, see section 8 of the SDS.
Personal precautions,
protective equipment and
emergency procedures
Eliminate all ignition sources (no smoking, flares, sparks, or flames in immediate area). Keep
combustibles (wood, paper, oil, etc.) away from spilled material. The product is immiscible with
water and will sediment in water systems. Stop the flow of material, if this is without risk. Collect
spillage. Prevent entry into waterways, sewer, basements or confined areas. For waste disposal,
see section 13 of the SDS.
Methods and materials for
containment and cleaning up
Avoid release to the environment. Contact local authorities in case of spillage to drain/aquatic
environment. Prevent further leakage or spillage if safe to do so. Do not contaminate water. Avoid
discharge into drains, water courses or onto the ground.
Environmental precautions
2 / 8
Material name: RTV Silicone Sealant - Red (pressurized)
14059 Version #: 02 Revision date: 05-29-2015 Issue date: 11-11-2014
SDS US