Cut Sheet

General Purpose Silicone Mold Release
DISCLAIMER: This information is accurate to the best of CRC Industries’ knowledge or obtained from sources believed by CRC to be
accurate. Before using any product, read all warnings and directions on the label. All products should be tested for suitability on a particular
application prior to actual use. CRC Industries, Inc. makes no representations or warranties of any kind concerning this data.
CRC Industries, Inc. Industrial Products Division Warminster, PA 18974
Technical Service: [phone] Customer Service: [phone] CRC On-Line: [phone]
Literature Reorder #TDS178 CRC On-Line # 178 REV. 2/12
VI. Performance Characteristics
Evaporation Rate
Very fast
VII. Directions
 For best results do not over-spray.
 Apply a light, even film to mold surface as needed when sticking occurs.
 To avoid marked parts, do not over apply.
 Hold can 10” to 12” from mold surface.
 Do not spray directly on plastics.
VIII. Package Description
Part Number Container Size
03300 16 oz Aerosol
IX. Disposal
Disposal requirements vary by state and local jurisdiction. All used and unused product should be disposed of in
conformance with local, state and federal regulations.
IX. Special Use Warnings
Aerosol Cans
Do not puncture, incinerate or store above 120F. Exposure to high temperatures may cause can to burst. Do not
place in direct sunlight or near any heat source. Aerosol cans will conduct electricity. Keep away from all live
electrical sources including battery terminals, solenoids, electrical panels and other electronic components. Failure to
observe this warning may result in serious injury from flash fire and/or electrical shock.
General
Use only in well ventilated area. Ventilation may be improved by opening a window or door or providing mechanical
assistance. Avoid continuous breathing of vapor and spray mist. Avoid contact with skin and eyes. If ventilation is
not adequate, respiratory protection should be worn. For more information regarding short term and long term
exposure, review this product’s Material Safety Data Sheet.