Cut Sheet

Heavy Duty Degreaser II
DISCLAIMER: This information is accurate to the best of CRC Industries’ knowledge or obtained from sources believed by CRC to be
accurate. Before using any product, read all warnings and directions on the label. All products should be tested for suitability on a particular
application prior to actual use. CRC Industries, Inc. makes no representations or warranties of any kind concerning this data.
CRC Industries, Inc. Industrial Products Division Warminster, PA 18974
Technical Service: [phone] Customer Service: [phone] CRC On-Line: [phone]
Literature Reorder #TDS177 CRC On-Line # 177 REV. 5/09
VI. Performance Characteristics
ASTM D-877 (Dielectric Strength)
42,100 volts
ASTM D-56 (Flash Point)
180°F
ASTM D-1130 (KB Value)
75
VII. Directions
• May be harmful to some plastics. Test on small area before using. Do not use on sensitive electronic
equipment such as tape decks, VCRs, computers, etc. Use one of CRC’s precision cleaner products.
• To remove grease, oil, hydraulic fluids and related contaminants, spray until clean. For hard to reach
areas, use the extension tube. For heavier soils, apply product and allow to penetrate for several minutes.
Re-apply and soil should lift off.
• Air dry or dry with a clean absorbent cloth.
• If necessary, repeat application.
• Allow to dry thoroughly and vent before reactivating system.
• For personal safety, do not apply while equipment is energized.
VIII. Package Description
Part Number Container Size
03120 20 oz Aerosol
03121 1 Gallon Bottle
03122 5 Gallon Pail
03123 55 Gallon Drum
IX. Disposal
Disposal requirements vary by state and local jurisdiction. All used and unused product should be disposed of in
conformance with local, state and federal regulations.
IX. Special Use Warnings
Aerosol Cans
Do not puncture, incinerate or store above 120° F. Exposure to high temperatures may cause can to burst. Do not
place in direct sunlight or near any heat source. Aerosol cans will conduct electricity. Keep away from all live
electrical sources including battery terminals, solenoids, electrical panels and other electronic components. Failure to
observe this warning may result in serious injury from flash fire and/or electrical shock.
General
Use only in well ventilated area. Ventilation may be improved by opening a window or door or providing mechanical
assistance. Avoid continuous breathing of vapor and spray mist. Avoid contact with skin and eyes. If ventilation is not
adequate, respiratory protection should be worn. For more information regarding short term and long term exposure,
review this product’s Material Safety Data Sheet.