Instruction manual
Portion Size & Drink Strength Adjustment for Model PIC-J (Refer to Figure B)
Tool required: #2 Flat Head screwdriver.
1. Dispense a drink to determine if drink is too strong,
weak or if portion size is correct.
2. Turn off power to machine at power switch.
3. Drink strength and portion size controls will be
found behind the drain tray. (Refer to Figure B) For
portion size adjustment, turn dial clockwise to
increase dispense volume. To decrease volume
turn dial counterclockwise. For drink strength
adjustment turn dial clockwise to increase drink
strength. To decrease strength turn dial
counterclockwise. Turn on power to machine and
dispense a drink to determine if drink strength or
portion is acceptable. If drink strength or portion is
not acceptable, turn off power to machine and
repeat adjustment steps until desired drink strength
or portion is achieved. Note: clockwise rotation will
result in a stronger drink and counterclockwise will
result in a weaker drink.
Note: Water flow rate is factory preset at approximately
0.80 ounces per second.
* To adjust flow rate, remove left side upper panel. Use flat head screwdriver and turn knob on respective
dump valve. WARNING: Do not adjust flow rate above the factory setting to prevent funnel overflow.
Using the Ambient Temperature Option (Refer to Figure C)
(On models equipped with this option)
The Ambient Temperature Option is only available on the left head of the machine.To
dispense ambient temperature product from the left head, flip the “hot/cold” switch
(behind the unit’s door and below the left hopper) in the “cold” position. To dispense
hot product from the left head, the “hot/cold” switch should be in the “hot” position.
Note: Water flow rate is factory set at approximately 0.80 oz per second. Do not adjust
flow rate above the factory setting to prevent funnel overflow.
Crathco Powdered Beverage Dispensers Page 7
Figure C
Figure B
PORTION SIZE ADJUSTMENT
TURN DIAL CLOCKWISE TO
INCREASE DISPENSE VOL-
UME
COUNTERCLOCKWISE TO
DECREASE DISPENSE VOL-
UME
DRINK STRENGTH ADJUST-
MENT
TURN DIAL CLOCKWISE TO
INCREASE DRINK STRENGTH
COUNTERCLOCKWISE TO
DECREASE STRENGTH
Service and Cleaning
Caution: When cleaning this unit, do not use cleansers,
liquid bleach, powders or any other substance that
contains chlorine. These products promote corrosion
of stainless steel and plastics parts.
Use of these products will void the warranty.
Daily Cleaning and Maintenance
1. Empty the drip pan as needed and wash daily in a solution of
dish detergent.
2. Rinse out the whipper chambers by placing the rinse switch
(located on the right of the dispensing valves when the door is
open) in the "ON" position. Dispense one to two cups until the water
is clean. Short bursts of dispensing may also help clean the chambers.
When completed, return the rinse switch to the "OFF" position.
3. Remove the hoppers and refill with product.
Figure D
!