Instruction manual

Crathco Powdered Beverage Dispensers Page 5
Adjustments
Portion Adjustment
(On models starting with PIC-2A-DC and PIC-3A-DC with portion control dispense switches)
1. Place a cup under the selected drink dispense nozzle.
2. Press and hold the dispense switch.
3. After a 10 second time delay, the machine is triggered into program mode and will begin dispensing.
4. Continue pressing the button until cup is approximately 2/3 full, then release the switch to prevent overfill. The
elapsed portion dispense time is saved to memory and will remain until the dispense switch is
reprogrammed.
5. Check the portion size by placing an empty cup under the desired dispense nozzle, then press and release
the dispense switch. The machine will dispense the preprogrammed portion size.
6. If the portion size is incorrect, repeat steps 1, 2, 3, 4 & 5 until the desired portion size is achieved.
(On models starting with PIC-33A with 3 portion sizes per head.)
1. Place a cup under the selected drink dispense nozzle.
2. Press and hold the S, M, or L button on the touch pad.
(Hold button throughout entire procedure.)
The programming mode will not be activated until you:
3. Press and release the Manual (top-off) button.
After releasing the Manual (top-off) button, the 10-second delay is activated.
4. After 10 seconds, product will begin to dispense.
5. Release the S, M, or L button when cup is approximately 2/3 full.
6. Check the portion size by placing an empty cup under the desired dispense nozzle, then press and release
the dispense switch. The machine will dispense the preprogrammed portion size.
7. If the portion size is incorrect, repeat steps 1, 2, 3, 4 & 5 until the desired portion size is achieved.
Three buttons per head are capable of being programmed.
Thermostat Adjustment (Refer to Figure A)
Note: The thermostat range is approximately 160 to 200 degrees Fahrenheit. The tank temperature is factory
set at approximately 180°F, making beverage temperature slightly lower than 180 degrees Fahrenheit.
Tool required: #2 Phillips screwdriver.
1. Unplug machine.
2. Remove the drip pan.
3. Remove the upper splash panel on the front of the machine
by removing the four Phillips head screws.
4. Locate the thermostat adjustment dial on the left side of the
control board. (Refer to Figure A)
5. To adjust the temperature of the water being dispensed, turn
the adjustment dial on the control board.
(Turn clockwise to increase the water temperature or counter
clockwise to decrease the water temperature)
CAUTION! Do not force the adjustment dial beyond its 270 degrees of rotation
or damage to the control board may occur.
!