Instruction manual

How to Dispense a Cup of Cappuccino

On models with manual dispense switches:

(Refer to serial tag to verify model number of your machine)

1. Place a cup under the selected drink dispense nozzle.

2. Push and hold dispense switch until cup is 2/3 full and then release switch.

On models starting with PIC-1ADC, PIC-2ADC and PIC-3ADC with portion control dispense

switches:

(Refer to serial tag to verify model number of your machine)

1. Place a cup under the selected drink dispense nozzle.

2. Push button for one second, then release to dispense one serving.

Note: Portion may be cancelled by push and release of the switch.

Note: Cup must rest flat on tray with 1/4” (6 mm) clearance between cup and spout. Contents can cause

severe burns if handled improperly.

Start-Up Procedures for Pump Units (PIC 2-DC & PIC 3-DC only):

(Refer to serial tag to verify model number of your machine)

Note: Pump units are not designed to be plumbed to pressurized water source.

1. Place a full 5 gallon water container within 3 feet vertically and 2 feet horizontally of the machine.

Drop the hose at the rear of the machine into the water container (The hose should extend to approximately 1 inch

from the bottom of the water container).

Note: Do not let the end of the hose touch the bottom of the container. Shorten the hose if necessary.

If you need a longer hose, remove the back access panel, unclamp existing hose, replace with longer hose

and

replace clamp.

3. Plug the power cord into a proper electrical outlet.

Turn the power switch to the “ON” position and allow the water tank to fill. The machine will make a sound

when this occurs. Allow 3-4 minutes for fill time.

After the water tank has filled, allow 30-45 minutes for the water to reach operating temperature (Green ready light

will illuminate when tank is up to preset temperature).

6. Remove the powder hoppers

and fill with desired powder product. IMPORTANT: Check to make sure that the auger

inside the hopper is correctly installed prior to filling. Reinstall powder hoppers.

7. Peel protective film off photo merchandiser cover.

Crathco Powdered Beverage Dispensers

Page 4