Specifications

Software Setup Process Overview
DMAN-0001 REV B 21
4.4 Installation Methods
This section provides guidelines that should be taken into consideration whenever a
Flexible Display will be installed or mounted for display.
NOTE: Reusable load points.
The innermost eye bolt load points are used for hanging the display:
+ from the ceiling
+ on the rolling cart
The hanging bracket load points are used for hanging the display:
+ on a wall mounted straight hanging bar
+ in the shipping crate
NOTE: Don’t Forget! The correct orientation of the bar is to have the OPEN END
DOWN.
4.4.1 Understanding Load Points
Load points are the pre-drilled holes in the hanging bar, positioned to provide safe and
optimum balance to the Flexible Display when mounted. Brackets, eye bolts and other
mounting hardware are attached at the locations identified in the diagram, below.
WARNING!
Do not attempt to drill additional holes in the hanging bar.
Do not attempt to mount the Flexible Display without a hanging bar.
Figure 12. Load Points on a Hanging Bar (and Key)
Outer end of bar
Center of bar
A B C
Key:
A ……………………………..Eye Bolt Assembly position (option 1)
B …………………..Bracket Assembly position (requires 2 holes)
C ………………………………Eye Bolt Assembly position (option 2)