Specifications

NanoLumens Flexible Display Setup and Operation Manual
20 DMAN-0001 REV B
Figure 11. Remove the Integrated Handles' Screws
3. Remove the hanging brackets using a 7/16” open end or a 7/16” socket with ¼”
ratchet driver.
4. Remove any eye bolts using a 7/16” open end or a pair of pliers.
5. With the handles, hanging brackets and eye bolts removed, slide the straight
hanging bar out.
6. Slide the curved hanging bar in.
NOTE: The correct orientation of the bar is to have the OPEN END DOWN.
TIP: Make the insertion of the curved bar easier by positioning one person at each
end of the curved bar, easing the bar through the individual support bracket
ribs.
7. Reinstall the integral handles. Secure handles with the screw using the #2 Phillips
screwdriver.
The display is now ready for any necessary mounting hardware.
4.3.2 Install a Straight Hanging Bar
Follow the steps provided in the instructions above, Section 4.3.1. Install a Curved
Hanging Bar, reversing the curved bar to a straight bar in steps 5 and 6.