Specifications

Changing Out the Hanging Bars
DMAN-0001 REV B 19
Load the Flexible Display onto the cart:
5. With the Flexible Display facing you, grasp the handle bars and carefully lift the
Flexible Display up off the floor, or out of its current position.
NOTE: Refer to the NanoLumens NL6 – 112” Flexible Display Specifications for weight
specifications.
6. Place the eye bolts over the cart‟s protruding long bolts (load points).
7. Secure using the cotter pins.
Figure 10. Close-up of Display Loaded to Cart After Securing with Cotter Pins
Front and Rear Views
4.3 Changing Out the Hanging Bar
The Flexible Display is shipped in the crate with the straight hanging bar installed.
Follow the steps in these sections to change the straight hanging bar to a curved hanging
bar, or vice versa.
Preparation Checklist
 Refer to Table 1. Components Shipped, and Table 2. Required Tools Not
Provided.
4.3.1 Install a Curved Hanging Bar
1. Carefully lay the display face-down, flat, on the debris-free floor or large table
work surface and provided protective cover.
2. Remove the integrated handles using a #2 Phillips screwdriver to remove each
handle‟s single screw.