Specifications

Changing Out the Hanging Bars
DMAN-0001 REV B 17
3. Grasping the handle bars, lift the display up and pull off of the cart.
NOTE: Refer to the NanoLumens NL6 – 112” Flexible Display Specifications for weight
specifications.
4. The Flexible Display is now ready for one of the following scenarios. Use the
following table to determine your next steps.
Table 3. Flexible Display Mounting Options
If the Display…
Then Do This…
…is already prepped and ready for
mounting…
Take the display directly to its mounting
destination.
…needs its hanging bar changed from a
straight to a curved bar (or vice versa)…
Refer to Section 4.3 Changing Out the
Hanging Bar.
…needs any mounting hardware configuration
modifications…
Refer to Section 4.4 Installation Methods.
NOTE: The Flexible Display software connection activity will be completed at the
mounting location. The soft, protective cover may be detached once mounted.
WARNING!
Do not attempt to mount the Flexible Display
without a hanging bar.
4.2.4 Load onto the Rolling Cart
These steps may be used when transferring a Flexible Display with either a straight or
curved hanging bar to the rolling cart.
If the eye bolt assembly is already installed in the centermost single holes of the hanging
bar, skip Steps 1-2-3 and proceed to Step 4.
Preparation Checklist
 Refer to Table 1. Components Shipped, column Shipped with Cart, and Table
2. Required Tools Not Provided.
Prepare the Flexible Display for the Rolling Cart: