Specifications
Table Of Contents
- SPA-100 Manual Cover Sheet
- Machine Introduction
- Specifications
- Manual Page
- Diagrams
- Basic Machine Diagram
- Machine and Tester Set-Up
- Machine and Guard Assembly
- Machine Base and Panels Assembly
- Motor and Tool Slide Assembly
- Tool Slide and Punch Holders
- Ram Slide Assembly
- Nest Assembly
- Nest Block Including Nests
- Micro Switch and Nest Stop Assembly
- Punch Holder Assembly (8 Position)
- Cam and Adjustment Assembly
- Test Assembly
- Test Block Assembly - Micro Switch Asseembly
- Controller and Circuits
- Termination Instructions
- Receiving Inspection
- Recommended Spare Tooling and Troubleshooting Tips
- Maintenance for SPA-100
- SPA-100 Parts List
INTRODUCTION
Your SPA-100 machine comes to you fully equipped and set up to terminate
the style of plug you have requested.
The SPA-100 will accommodate those small connector configurations such
as 4 position, 4 contacts (4x4); 6 position, 2 contacts (2x6); 6 position, 4 contacts
(4x6); and 6 position, 6 contacts (6x6). -Consult factory-
When set-up to do so, this machine will accommodate both small and large
connectors alike, easy changeover from one to the other.
It is also electrically powered and does not require high-pressure airlines. It
is are portable enough to be moved around easily and their straightforward design
allows setup people to make changes in minutes.
All machines have full test capability with the cable tests performed as part
of the termination procedure.
1