Specifications
Table Of Contents
- SPA-100 Manual Cover Sheet
- Machine Introduction
- Specifications
- Manual Page
- Diagrams
- Basic Machine Diagram
- Machine and Tester Set-Up
- Machine and Guard Assembly
- Machine Base and Panels Assembly
- Motor and Tool Slide Assembly
- Tool Slide and Punch Holders
- Ram Slide Assembly
- Nest Assembly
- Nest Block Including Nests
- Micro Switch and Nest Stop Assembly
- Punch Holder Assembly (8 Position)
- Cam and Adjustment Assembly
- Test Assembly
- Test Block Assembly - Micro Switch Asseembly
- Controller and Circuits
- Termination Instructions
- Receiving Inspection
- Recommended Spare Tooling and Troubleshooting Tips
- Maintenance for SPA-100
- SPA-100 Parts List
MAINTENANCE FOR SPA-100
1. Use a soft brush to lightly remove any debris that may build up on machine.
Always keep the nest cavity clean.
2. Grease machine at the top, once a month or every 500 hours of service.
With the machine off, take a cloth underneath the ram and remove excess
grease. This should be done from time to time between greasings to assure
that grease does not come in contact with product.
3. When replacing tooling, store unused tooling in plastic or wax paper after
being lightly sprayed with light oil. When replacing tooling lightly brush off
tooling working surfaces and wipe oil clean from tooling. Do not oil the
gibbs, as this will break down the grease that has been placed in them from
the factory.
4. A maintenance program should be established for service on a regular basis.
The amount of usage will determine whether this should be performed daily,
weekly or monthly.
5. Take extra care that no chemicals remain in the nest portion of the machine
when resuming production. This will prevent any possible chemical
reaction.
6. Contact a service representative for any further information.
WARNING! When maintenance is being performed, please make sure
power is off!
23