Owner`s manual

Technical Specifications:
Output Power Rating
BV-60H 50 watts RMS @ 5% THD 8 or 16 ohm load, 120 VAC
BV-120H 100 watts RMS @ 5% THD 8 or 16 ohm load, 120 VAC
Gain Channel 1 66dB, tones at “10” @ 1kHz
Channel 2 101dB, tones @ “10” @ 1kHz
Tone Control Range
Channel 1
Low 16dB @ 100Hz
Mid 20dB @ 300Hz
High 10dB @ 10kHz
Channel 2
Low 15dB @ 100Hz
Mid 13dB @ 500Hz
High 10dB @ 10kHz
Presence 5dB @ 10kHz
Input Impedance 1M ohm
Maximum Signal Accepted 2.8V peak to peak
Tube Types
Preamp 12AX7A (3)
Power Amp BV-60H: 12AX7A (1), 6L6GT/5881 (2)
BV-120H: 12AX7A (1), 6L6GT/5881 (4)
Line Out Level 1.2V RMS nominal
Power Requirements
BV-60H 115V 60Hz, 110VA; 2.5A Slo-Blo Fuse
BV-120H 115V 60Hz, 180VA; 5A Slo-Blo Fuse
Size and Weight 12”H x 30.25”W x 10”D, 50lbs.
Crate continually develops new products, as well as improves existing ones. For this reason, the specifications and information in this manual are subject to change without notice.
The BV-60H and 120H are covered with high-quality, durable Tolex
®
. To keep them looking their best, avoid
abrasive cleansers. Wipe the cabinets clean using a slightly dampened soft cloth. Do not spray cleaners directly
into the amplifier. Never use brass cleaners on the hardware since they could damage their protective coatings.
®
©1996 SLM ELECTRONICS • A division of St. Louis Music • 1400 Ferguson Avenue • St. Louis, Mo 63133
P/N 47-631-03 • 09/96
®
BV-60H/120H All-Tube Professional Series Guitar Amplifiers