Assembly Instruction

VINTNER PANTRY
Page 5 of 5
WALL MOUNTING ASSEMBLY
Made in China - r03
WALL
plastic
anchor
mounting
bracket
pan head
screw
mounting
screw
cabinet
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
For added safety and stability, it is recommended that the wall mounting hardware be
installed. For safe mounting, it is essential to use wall anchors appropriate to your wall type
(i.e. plaster, drywall, concrete, etc.). Mount to wood studs whenever possible.
A) Attach 1 mounting bracket to top of unit as shown, using 1 pan head screw.
B) Determine the final location of unit. Mark position on the wall, approximately 2" below the
bracket mounted to the back of the unit.
C) Drill a hole in the wall stud. If the wall stud is not available, drill a hole in the wall that is
slightly smaller in diameter than the anchor. Gently tap the plastic anchor until the flange of
the anchor is flush with the wall.
D) Attach the mounting bracket to the wall by inserting 1 mounting screw through the wall
fitting and into each plastic anchor in the wall.
E) Place the unit so the wall fitting on the back edge is aligned with the wall fitting on wall.
F) Lace one end of the wall strap through both fittings, and into the other end of the strap.
G) Pull the strap tightly until secure. Repeat steps for remaining fitting and wall strap.
Wall mounting assembly is now complete.
NOTE: If you are unsure about your wall
type or what mounting method you
should use, consult a qualified
professional or your local hardware store.
A
C
D
mounting
bracket