Assembly Instruction
Made in Vietnam - r02 Page 2 of 2
TWIST TABLE
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
3 With the assistance of another adult, position legs as
shown. Fit center connector into assembly and align
holes of center connector with holes of 4 legs as
shown. Loosely attach center connector to each leg
with 1 spring washer and 1 small bolt, using an allen
wrench.
4 Carefully position unit upright. Secure legs to base with
4 screws as shown, using a phillips head screwdriver.
Do not over tighten the screws. At this point, fully tighten
bolts with an allen wrench. Do not over tighten.
5 Attach base to tabletop with 4 flat washers, 4 spring washers and
4 large bolts as shown, using an allen wrench. Position unit upright.
Assembly is now complete.
NOTE: Do not fully
tighten bolts
NOTE: Do not over
tighten the screws
and bolts
center
connector
Clean surfaces with a dry or damp
soft cloth. Do not use abrasive
cleaners. Do not use furniture wax
or polish as the unit is finished with a
protective clear lacquer. It is recom-
mended to use coasters to protect
surface from heat and water.
CLEANING & CARE