Assembly Instruction

HARDWARE

TOOLS REQUIRED

COMPONENTS

ASSEMBLY

Made in Vietnam - r02 Page 1 of 2

Thank you for purchasing the Twist Table. This page

lists all the contents included in the box. Please take

time to identify the hardware as well as the individual

components of this product. As you unpack and

prepare for assembly, place the contents on a carpeted

or padded area to protect them from damage.

Note: 2 people are required to safely assemble this product.

TWIST TABLE

Missing hardware?

Please call

800.606.6387 for

replacements.

1 - center

connector

1 - tabletop

allen wrench

(included)

phillips head screwdriver

(not included)

(We recommend the use of hand tools instead of power tools)

4 - legs

tabletop

base

leg

wood dowel

Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com

4 - screws 4 - small

bolts

4 - spring

washers

2 Fit pre-assembled wood dowels of 4 legs into

corresponding holes of base as shown.

1 Place tabletop upside down onto a clean, padded

surface. Using an allen wrench, remove base from

tabletop as shown.

PAGE 1
TWIST TABLE HARDWARE 4 - screws Missing hardware? Please call 800.606.6387 for replacements. 4 - spring washers 4 - small bolts TOOLS REQUIRED phillips head screwdriver (not included) allen wrench (included) (We recommend the use of hand tools instead of power tools) Thank you for purchasing the Twist Table. This page lists all the contents included in the box. Please take time to identify the hardware as well as the individual components of this product.
PAGE 2
TWIST TABLE NOTE: Do not over tighten the screws and bolts center connector NOTE: Do not fully tighten bolts 3 With the assistance of another adult, position legs as shown. Fit center connector into assembly and align holes of center connector with holes of 4 legs as shown. Loosely attach center connector to each leg with 1 spring washer and 1 small bolt, using an allen wrench. 4 Carefully position unit upright. Secure legs to base with 4 screws as shown, using a phillips head screwdriver.