Assembly Instruction

TRIAD WINE TOWER
Page 5 of 5 Made in China - r05
Customer Service 800.967.6696 | Latest instructions available at www.crateandbarrel.com
NOTE:
If you are unsure about your
wall type or what mounting
method you should use, consult
a qualified professional or your
local hardware store.
A
C
medium
screw
wall
bracket
plastic
anchor
large
screw
wall
strap
D
F
wall
bracket
Safety Mounting Assembly
For added safety and stability, it is recommended that
the wall mounting hardware be installed. For safe
mounting, it is essential to use wall anchors appropriate
to your wall type (i.e. plaster, drywall, concrete, etc.).
Mount to wood studs whenever possible.
A) Attach wall bracket to top of unit using 2 medium
screws as shown.
B) Determine the final location of unit. Mark position
on the wall, approximately 2" below the wall bracket
mounted to the back of the unit.
C) Drill a hole in the wall stud. If the wall stud is not
available, drill a hole in the wall that is slightly smaller in
diameter than the anchor. Gently tap the plastic
anchor until the flange of the anchor is flush with the
wall.
D) Attach wall bracket to the wall by inserting 2 large
screws, and into the plastic anchor in the wall.
E) Place the unit so the wall brackets on the back edge
are aligned with the wall brackets on the wall.
F) Lace one end of the wall strap through both
brackets, and into the other end of the strap.
G) Pull the strap tightly until secure.
H) Repeat steps A-G for remaining wall brackets and
wall straps.
Safety mounting assembly is now complete.
WALL